Specifications

NOTE: The [#] key can be
6. To terminate the programming mode, press [#] .
pressed to cancel an
uncompleted programming
You will hear the PARTNER PagePac dial tone.
option; you will hear the
programming mode dial tone.
Night Bell
The PARTNER Plus/II system provides a mode of operation called Night
Service. By pressing a single button on the system phone at extension
10, the customer can cause incoming after-hours calls to ring on a
specified group of extensions.
The PARTNER PagePac module provides additional capabilities to the
Night Service feature by allowing Night Bell to ring to one or more paging
zones.
Night Bell Programming Procedure
Refer to your PARTNER Plus/II
1.
manual for complete Night
Service programming procedures.
2.
3.
4.
MLS-18D
Make the physical connections for Night Bell service as described in
Section 5.
Use the PARTNER Plus/II Line Ringing feature to set all lines on the
Night Bell extension to “No Ring.”
Using the PARTNER Plus/II Night Service Group Extensions (#504)
programming feature, place the Night Bell Station into the Night
Service group.
Use the PARTNER Plus/II Night Service Button (#503) procedure to
activate the Night Service feature (if not already done) see Figure 6-1.
MLS-12D
MLS-34D
NIGHT SERVICE
BUTTON
Figure 6-1 Turning Night Bell Service On/Off
Programming 6-9