Specifications

Night Bell Service
IMPORTANT:
Station Mode
Considerations
NOTE: Refer to Section 6 Night
Bell programming instructions
and Section 7 for Operation
Information.
IMPORTANT:
All lines on the Night Bell
extension should be set to “No
Ring”. (Refer to Sections 6
and 7 for Programming and
Operation.)
NOTE: Connect RJ-11 cable
from PARTNER PagePac
module Night Bell port to
appropriate station port. (Refer to
Sections 6 and 7 for
Programming/Operation.)
To ensure full use of ''PFT'' (Power Failure Transfer) in your PARTNER
Plus or PARTNER II phone systems during an emergency or power
outage conditions when selecting “Station Mode,” these extensions are
NOT recommended for use for primary paging areas:
■ PARTNER Plus system: Stations 10, 11, 16, 22, 28
■ PARTNER II system: Stations 10, 11, 16, 22, 28, 34, 40, 46, 52
The PARTNER PagePac provides a NIGHT BELL port. This RJ-11 jack
connects to a station port (Extension) on the PARTNER system that has
been configured for night bell service (see Figure 5-4). Once configured,
the PARTNER PagePac can detect an incoming ring signal and generate
tones over the paging system until the incoming call is terminated or
someone answers the call. The Night Bell feature has lower priority than
Microphone access, Paging and Doorspeaker, but has a higher priority
than background music.
206
MODULE
FROM PARTNER
PAGEPAC
NITE BELL PORT
PARTNER
PAGEPAC
MODULE
(WALL-MOUNT
INSTALLATION)
PARTNER
PAGEPAC
NIGHT BELL
PORT
Figure 5-4. Night Bell Service Installation
Accessory Features 5-5