Specifications

To Program/Test a second
Doorspeaker, repeat these steps
with the appropriate zone number.
NOTE: The default Doorspeaker
action is Door Alert Mode; refer
to Section 6 for Ringdown Mode
information.
NOTE: To access the
PARTNER system, refer to the
previous page.
Refer to Section 6 for
programming options.
Refer to Section 7 for complete
operating information.
3. Dial the zone number you wish to program as a Doorspeaker
Mode zone (1, 2).
You should hear two beeps followed by the programming dial tone in
the telephone receiver.
4. Dial [2]
(to select Doorspeaker Mode).
You should hear three beeps followed by the programming dial tone.
Test
5.
6.
7.
8.
9.
Dial [#] (to return to PARTNER PagePac dial tone).
You should hear the PARTNER PagePac dial tone in the telephone
receiver.
Hang up.
Have your assistant press the Doorspeaker button (for selected zone
1 or 2).
The person at the door should hear the door alert tone from the
Doorspeaker.
You (the person at the telephone) should hear the door alert tone
over the other zones’ loudspeakers.
Pick up the phone receiver and access the PARTNER system.
You should hear in the telephone receiver 1 beep if the button at
door 1 has been pressed, or 2 beeps if the button at door 2 has been
pressed.
You should now have two-way communications with the Doorspeaker.
Dial [O]
[P] [E] [N] (to open remote door; only if strikeplate is used).
The door’s electronic strikeplate should open so the person at the
door can enter.
10. If the person at the door leaves the door open more than 30 seconds,
a door ajar alert can be heard over the page/speaker zones.
4-6 Doorspeaker Mode Installation