Specifications

Quick Test (Doorspeaker Equipment)
■
NOTE: If tests are not
as expected, refer
to “Troubleshooting” in
Appendix A.
IMPORTANT:
Only Doorspeaker PEC
5330-120 is compatible with
the PARTNER PagePac
module. Do NOT use AT&T
PARTNER Plus Doorphone
PEC 5324-003 (there should be
NO LED on the doorspeaker
face plate).
■
At this point your PARTNER PagePac module has been installed along
side your PARTNER Plus or PARTNER II Phone system and you have
completed the Page/Speaker installation steps outlined in Section 2.
In addition, you should have installed the necessary Doorspeaker
equipment (Doorspeaker, electronic strikeplate, door ajar device,
connecting blocks, and wiring) within your business.
The following test will ensure your PARTNER PagePac is operating
correctly by providing two-way communications with a Doorspeaker,
opening a doors strikeplate contact closure and determining if a door
ajar device has been activated.
You Will Need:
A PARTNER System telephone and another person to activate the
Doorspeaker.
Zone 1 and/or Zone 2 (Configured for Doorspeaker Mode)
If zone 1 or 2 has been configured as a Doorspeaker Mode zone, you will
need to tell (program) this to the PARTNER PagePac module.
To Access PARTNER PagePac Module
For Dry Loop Mode (connection to Page Port) you will need to dial:
[INTERCOM] [7] [0].
For Station Mode operation, you will need to dial [INTERCOM],
followed by the extension number connected to the PARTNER
PagePac paging system. For example, if you have configured your
PARTNER PagePac paging system with a cable connecting from the
PARTNER PagePac STN l/N port to extension 20 of the PARTNER
Plus system module, you would dial [INTERCOM]
[2] [0] the first time
you wish to access PARTNER PagePac features and programming
capabilities.
For Trunk Adapter Mode you will need to select the trunk which is
connected to the PARTNER PagePac unit by pressing the appropriate
[LINE] button. For standard telephone access, use Direct Line
Pickup.
You should hear the PARTNER PagePac dial tone in the telephone
receiver.
Quick Programming
1. Dial [*]
[*] (to start programming).
You should hear a different dial tone in the telephone receiver.
2. Dial [6]
[0] (for type of zone).
You should hear two beeps in the telephone receiver.
Doorspeaker Mode Installation 4-5