Specifications

Connection Block
NOTE: Auxiliary Port can utilize
Zones 1 and 2 on the PARTNER PagePac module have an RJ-45
an RJ-11 modular cable direct to
modular jack interface. To connect the various audio pair wires (and
PagePac or AmplCenter RJ-11
contact closure pair wires), it is recommended you use a standard
jack. No Connection block is
needed.
full-modular 8-pin cable to connect from the PARTNER PagePac module
to an AT&T 103A block, which in turn can connect to a 66-type connection
block if needed. Figure 3-3 provides a typical wiring example and includes
the pinout connections for the RJ-45 cable, as well as the 103A block
terminal pinouts.
TO SPEAKER RUNS /
CONNECTING BLOCKS OR
REMOTE AMPLIFIERS
ZONES 1 OR 2
RJ-45
SPEAKER/
103A
RJ-45 WIRE
TERMINAL
TERMINAL
OUTPUT
REMOTE AMP
➡ COLOR
NUMBER
OUT
WIRE PAIRS
AUDIO PAIR
+
➡
RED
4
2
ZONE 1 (OR 2)
SPEAKERS
–
➡ GREEN
5
1
CONTACT
CLOSURE
+
➡ BLACK
3 5
PAIR
–
➡ YELLOW
6
6
NOTE: YOU MAY CONNECT DIRECT
TO SPEAKERS OR AMPLIFIERS OR
AN ADDITIONAL CONNECTING
BLOCK (e.g. 66 TYPE BLOCK)
AT&T 103A BLOCK
(OR EQUIVALENT)
MODULAR RJ-45
CONNECTOR
(8-WIRE)
RJ-45 MODULAR CABLE FROM
NOTE: IT IS RECOMMENDED
PARTNER PAGEPAC ZONE 1 OR
THAT EACH ZONE HAVE ITS
ZONE 2 (PROVIDED)
OWN CONNECTING BLOCK
Figure 3-3 Example Speaker / Remote Amplifier Connection Block Wiring
3-6 Page/Speaker Mode Installation