Specifications

Run Speaker
There are two methods of wiring speakers: from speaker-to-speaker and
Cable
Home Run (refer to Figure 3-2). When wiring speaker-to-speaker, cable is
run from the PARTNER PagePac module to the nearest speaker location,
from that location to the next, and so on, until all locations are connected.
When wiring Home Run, cable is run from the PARTNER PagePac
module to each speaker location. A combination of both methods may be
used, but the maximum distance for each cable run is 600 feet.
Recommended cable size is 24-22 AWG minimum with “shielded” cable
for all speakers with Talkback.
Connect Speaker
When all speakers have been installed, connect speaker cable using one
Cable
of the methods described above. Each zone must have its own dedicated
speaker cable run. Refer to Figures 3-2 and 3-3, along with the installation
Instructions provided with your speakers for specific installation procedures.
HOME RUN METHOD
TWO
WIRES
66-TYPE
CONNECTION
BLOCK
TWO
WIRES
AT&T 103A
CONNECTION
BLOCK
TO ZONE 1 OR
ZONE 2 PORT
TWO
WIRES
SPEAKERS
SPEAKER-TO-SPEAKER METHOD
SPEAKERS
AUDIO PAIR
AT&T 103A
CONNECTION
BLOCK
TO ZONE 1 OR 2
ZONE 2 PORT
Figure 3-2 Speaker Run Methods
Page/Speaker Mode Installation 3-5