Specifications

PARTNER PagePac Paging Access
Primary Paging
Zones
(Zones 1 and 2)
Refer to Section 4 for
Doorspeaker Mode Installation.
Refer to Section 5 for adding
Night Bell service.
The PARTNER PagePac can be configured differently depending on your
particular situation. Two primary zones (Zone 1 and Zone 2) can be
individually configured for Page/Speaker Mode, Doorspeaker Mode, or
Remote Amplifier Mode.
Both zones 1 and 2 provide a 4 watt on-board amplifier power switch to
drive voice coil (3.4V) speakers in Page/Speaker Mode and Doorspeaker
Mode. Each zone provides a RJ-45 jack which supplies an audio pair
(which is used in all modes), a contact closure pair (used for the
Doorspeaker and Remote Amplifier Modes) and four wires for the Door
Bell and Door Ajar inputs (used in Doorspeaker Mode). The primary
paging zones provide paging, hands-free talkback (programmable), music,
and tone output on the audio pair.
Talkback Capabilities
NOTE: Auxiliary paging zone will
NOT support talkback.
See Table 3-1 for available
speakers.
Remote Amplifier
The PARTNER PagePac has the unique ability to provide individuals with
the ability to talkback over selected speaker zones 1 or 2. “Hands-Free”
talkback is available in both Page/Speaker and Doorspeaker Modes. Refer
to Section 6 for complete programming information for this feature.
Mode (Zones 1 and 2)
Refer to Figures 3-2 and 3-3.
In “Remote Amplifier Mode,” the Audio Pair provides the signal inputs to
the amplifier. and the control closure pair is used to operate the
NOTE: PagePac 6 Plus cannot
Page/Music switch on the amplifier. The Door Bell and Door Ajar inputs
be used as a remote amplifier.
are ignored.
A Remote Amplifier zone provides the same paging features as a
Page/Speaker zone. The chief difference is that the PARTNER PagePac
module closes the relay on the control closure pair when it is presenting a
signal (Page, Tone, or Music) on the audio pair, and opens the relay contacts
when the zone is idle (see Figure 3-1 for example installation).
Auxiliary Paging Zone (Zone 3)
NOTE: Zone 3 provides a Zone 3 of the PARTNER PagePac module is called the Auxiliary Paging
0 dBm signal for a Remote
Zone. This Zone is intended for connection to a paging amplifier, such as
Amplifier,
the AT&T AmpIiCenter series. The Auxiliary Paging Zone operates in the
NOTE: The Auxiliary Paging
same fashion as a Primary Paging Zones (zones 1 and 2) configured in
Zone (Zone 3) cannot be
Remote Amplifier mode. The chief difference is that, unlike Zones 1 and 2,
configured in Doorspeaker Mode.
Zone 3 does not provide an on-board 4-watt amplifier paging or the ability
to provide talkback.
NOTE: PagePac 6 Plus cannot
be used as an auxiliary amplifier.
3-2 Page/Speaker Mode Installation