Specifications

Trunk Adapter Connections (Trunk Adapter Mode Only)
If Trunk Adapter Mode has been selected as the best interface connection
for your requirements (pages 2-7 and 2-8), continue with the following
procedure:
Required materials:
➊ – AT&T PARTNER PagePac Trunk Adapter (PEC 5335-301)
➋ – Standard modular telephone cord (7 feet, provided)
Follow the steps below to install the AT&T Trunk Adapter (see Figure 2-3):
1.
2.
4.
5.
Connect the PARTNER PagePac Trunk Adapter modular cord to the
PARTNER PagePac module STN/lN port.
Connect the PARTNER PagePac Trunk Adapter jack J2 to the
available Trunk (Line) Port on the selected PARTNER system module.
Route cord(s) through bracket at bottom of modules. Leave at least
two feet of slack so you can remove modules.
Connect the PARTNER PagePac Trunk Adapter 24 volt power supply
(supplied) to AC power.
TO 206, 200
OR 400 MODULE
TRUNK (LINE)
PORT
4 WIRE RJ
CABLE
➋
TO PARTNER
PAGEPAC
STN/IN PORT
TO 24 POWER SUPPLY
(INCLUDED WITH PARTNER
PAGEPAC TRUNK ADAPTER
PEC 5335-301)
206
MODULE
PARTNER PAGEPAC
UNIT
Figure 2-3 Trunk Adapter Installation for PARTNER PagePac
Module
2-14 Installation