Specifications

Interface Mode Connections
NOTE: Additional installation
instructions are provided for
Trunk Adapter Mode on
page 2-10.
Once you have decided on the best interface mode for your PARTNER
system configuration (Dry Loop Mode, Station Mode, or Trunk Adapter
Mode), follow the steps below to make the appropriate interface
connections:
1.
2.
3.
Use a standard 7-foot, 4-pin RJ-11 modular cable (provided) to
connect the PARTNER Plus or PARTNER II system to one of the
following PARTNER PagePac modules (refer to Table 2-1 and Figure
2-2). Connect the modular cable from the PARTNER PagePac
module’s “STN I/N” port to:
➊ – Page Port on processor module (for Dry Loop Mode) or
➋ – Station Port (for Station Mode), or
➌ – Trunk Port (for Trunk Adapter Mode).
Route cord through bracket at bottom of modules. Leave at least
2 feet of slack so that you can easily reconnect cord during
replacement.
Plug the PARTNER power cord into the AC outlet, 110V/60 Hz. Use
the special power cord (supplied) to connect the PARTNER PagePac
unit to the selected AC outlet.
➊
FOR DRY LOOP
MODE CONNECT
TO “PAGE" ON
PROCESSOR
MODULES
➌
FOR TRUNK
ADAPTER
MODE CONNECT
TO TRUNK
➋
FOR STATION
MODE CONNECT
TO EXTENSION
7 FOOT LONG
4 WIRE - FOR
TELCO ACCESS
(PROVIDED)
FROM PARTNER
PAGEPAC
STN/IN PORT
206
PROCESSOR
MODULE
MODULE
(PARTNER PLUS,
PARTNER II)
PARTNER PAGEPAC
MODULE
(WALL-MOUNT
INSTALLATION)
Figure 2-2 Cable Connections for Selected Interface Mode
Installation 2-13