Specifications

Connecting to AC Power
CONNECTING
AC POWER
A Connect the AC power cord to
the AC connector at the back of the
PARTNER PagePac module. Press
firmly until it clicks as it locks into place.
Plug the other end of the power
cord into a grounded wall outlet. The
outlet must not be controlled by a switch.
The green light below the night bell
jack on the module should come
on (see Figure 2-2). If it does not,
see "Troubleshooting” in Appendix A.
CONNECTING
AC POWER
(USING MOUTING BRACKET)
AC CORD
MOUNTING
BRACKET
B If the PARTNER PagePac
mounting bracket has been used to
install the unit to a wall, the AC cord
can be fed through the bracket for a
cleaner looking installation.
Installation
2-7