Specifications

Mounting the PARTNER PagePac Module (Flat onto Wall or Desk)
For either desk or wall mounting,
Hold the PARTNER PagePac in
attach the 4 rubber feet to the mounting
tracks on the bottom side of the module.
MOUNTING FLAT
ONTO WALL . . .
go to steps 2 and 3.
TABLE MOUNTING...
skip steps 2 and 3.
Place the module flat
on the surface with
the rubber feet down.
The module should
not slide easily.
Go to “Connecting
to AC Power” on
the next page.
Insert the screws into the screw
Go to next page.
place on the wall with the telephone
jacks facing left. Leave at least 1 foot
clearance at the top, bottom and back,
and at least 2 feet in front. This allows
you to access the jacks and provides
adequate ventilation.
Note: Mount the PARTNER PagePac
within 5 feet of the PARTNER Plus or
PARTNER II phone system.
holes at the top and bottom of the mod-
ule. Tighten until the rubber feet are snug
against the wall. There must be a 3/8”
gap between the wall and the rest of the
module. Do not overtighten—the module
will warp and fail to operate.
2-6 Installation