Specifications

Mounting the PARTNER PagePac Module (Using Mounting Bracket)
PARTNER
PARTNER
PAGEPAC
CARRIER
MODULE
/
MOUNTING
BRACKET
The PARTNER PagePac module
provides a mounting bracket at the back of
the unit. The bracket allowsthe PARTNER
PagePac to be mounted to a wall, close to
the PARTNER Communication System
carrier. Although the PARTNER Pagepac
can be mounted next to the carrier, the
module cannot be installed directly into the
carrier.
MOUNTING
BRACKET
POSITION BRACKET
ONTO SCREWS
IN WALL
Use screws appropriate for the
type of wall surface. Drive screws so
head of screwisapprox.5/16“ from wall
surface. Position mounting bracket
key-hole openings over screw heads.
Once bracket is in place onto screws, the
PagePac unit should be secure and not
easily moved side to side. You may need
to tighten screws slightly to provide a
better fit to the bracket.
I
Wall Mount Template 3.5*
Use the Wall Mount Template and
the included instructions to mark the
mounting screw locations on a wall. The
Wall Mount Template is located at the end
of this section.
Note: Mount the PARTNER PagePac
within 5 feet of the PARTNER Plus or
PARTNER II phone system.
For mounting the PARTNER
PagePac FLAT onto a wall
surface, continue to the
next page . . . .
If you have completed
mounting the PARTNER
PagePac using the mounting
bracket, turn to page 2-7 for
Connecting to AC Power.
Installation 2-5