Installation guide

A
Application Notes
Night Bell
There are two different Night Bell connections possible with the PagePac
Pius Controller. These are illustrated in figure A-1.
From an EKTS
A programmer needs to know what type of Night Bell connection exists
Telephone System
between the telephone system and the PagePac Plus. In one case,
typically with an EKTS telephone system, where Night Bell input is wired
to one of the eight PagePac Plus onboard zones (one of the eight onboard
zones corresponding to the eight switches on the rear of the controller),
then you will need to configure it as an input zone, just as any other (door
bell, alarm system, door ajar, etc.). See tables 2-13, 2-21, and 2-22 in
section 2 for programming instructions.
From a PBX or
Centrex System
In the other case, typically with a PBX system that produces a ring voltage
output, the Night Bell connection is not wired to one of the eight input
zones, but to another connector on the rear of the PagePac Plus (see
Installation Guide).
You will want to enable the Night Bell tone, whenever this input is
received, and route it to selected zones. Refer to table 2-19 in section 2
for programming instructions.
Application Notes
A-1