Installation guide

Using Telephone to Respond to Doorbell Tone
Within 10 Seconds
If you pick up your telephone and access the paging system within 10
seconds of the sounding of the doorbell tone, the paging system will
automatically route your voice to the door speaker at the door. You need
not dial a zone code. However, if a Connect password has been installed
in your system, you will need to access the PagePac Plus and enter the
password before being routed to the door speaker.
After 10 Seconds
Unlock the Door
If 10 seconds has elapsed before you access the paging system, you will
hear a dial tone, and need to enter a zone code to reach the door
speaker, in order to talk to the person who rang the doorbell.
If you have more than one security door equipped with doorbell and/or
door speaker, you will want to configure a group zone for audio output
(with talk-back) to the door speakers, so that you can page all of them at
once, in order to ask the visitor to identify the door he is at. Then you can
dial the code for the speaker phone at that door, in order to speak further
to him, or dial the door control code to unlock that door.
If the door is equipped with a locking device that has been connected to
the PagePac Plus system, you can use your telephone to unlock it and
permit the door to open.
If you are still talking to the person at the door via the telephone paging
system:
■
Dial the zone code of the door lock mechanism, to send the unlock
signal.
If you are NOT currently engaging the paging system via your telephone:
■
■
■
Dial the paging extension or trunk.
Hear dial tone.
Enter the Connect password (if any). Hear Confirmation tone.
Enter the zone code for triggering the door to unlock.
Operation
3-3