Installation guide

Power UP
When the PagePal Plus Controller is first powered up, it polls the zones to
determine how many (if any) zone expansion modules are present. (The
Controller has the ability to serially access Up to 48 external zones.)
System Administrator
Enter Programming To enter the programming mode, first access the paging system by dialing
Mode
its proper extension or trunk, then dial the Connect password (if one has
been activated), then dial the Programming password (if one has been
vated) and always dial [
* ] [ * ] to enter programming mode. Refer to
the programming details (section 2) or to the Programming Quick
Reference Chart for instructions to program the PagePac Plus Controller.
Connect Password
To institute a Connect password, refer to programming steps for "Connect
Password" in section 2.
To institute a Programming password, refer to programming steps for
"Programming Password" in section 2.
For specific examples of PagePac Plus applications, see the Application
Notes, following this section.
End User
Programming
Password
Using Telephone to Make a Voice Page
1.
NOTE: If the wrong password is
2.
entered, you will lose the dial
tone. Hang up and start again.
NOTE: The pound sign (#) takes
3.
you back one step (to the dial
tone, in this case) so that if you
entered the wrong zone code,
4.
you can back out of it and
reenter the correct code.
5.
Dial the paging system extension or trunk. Hear system dial tone.
Enter the Connect password (if one has been established). Hear
confirmation tone.
Dial the zone code. (Refer to the Quick Reference Card.) Hear
confirmation tone.
Speak your paging message.
(Optional) If you wish to transfer to a different paging zone (while
you are already active in a zone), simply dial the extension of the
other zone, without hanging up. You will hear a tone confirming you
have accessed the other zone.
3-2 Operation