Installation guide

Audio Source Enable
The primary use for this feature is to allow the PagePac Plus to be used
for door service. If optioned, whenever a selected zone is active (i.e., the
doorbell pushbutton), an audio source (either Telephone Access or
Attendant Access) will be routed automatically to a zone (the door
speaker-phone) selected in "Audio Routing," below. The default for this
option is NONE.
Programming Steps
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
1.
2.
3.
Dial [ 9 ] [ 6 ] to select Audio Source Enable.
Hear a DOUBLE beep.
Enter the input zone number. Use ALlAS numbers, if optioned.
Otherwise, use Physical zone/group numbers.
Hear a DOUBLE beep.
Enter [
0 ] (NONE), [ 1 ] (AA, Attendant Access), or [ 2 ] (T/R,
Telephone Access) to select the audio source (or none) to be
enabled when this zone is activated.
Hear TRIPLE beeps.
To verify your selection, Dial [
9 ] [ 7 ] and repeat steps 2 and 3, above.
Table 2-24 summarizes the Audio Source Enable options.
Table 2-24. Audio Source Enable
Feature
Mode Option/
Verify
Dial
Listen
For
Zone/Group
Selection
Listen
For
Choose Option
Listen
For
Default
Audio
Source
Enabled
To Select
To Verify
96
97
Double
Beeps
Enter the input
zone number
Double
Beeps
0 - None
1 - AA
2 - T/R
Triple
Beeps
None
2-34 Programming The Controller