Installation guide

To verify the tone option for a given input zone, dial [ 9 ] [ 3 ] and repeat
steps 2 and 3 above.
These actions are summarized in table 2-22. The different tones are
described below.
Table 2-22. Tone Selecting
Feature
Mode Option/
Verify
Dial
Listen
For
Zone/Group
Selection
Listen
For
Choose Option
Listen
For
Default
Activate To Select
92
Double
Enter the input
Double
Tone via
To Verify
93
Beep
zone number.
Beep
an Input
Closure
0 – None
1 – Chime
2 – Siren
3 – Warble Siren
4 – Night Bell
5 – Fast Ring
6 – Steady Tone
7 – Door Bell
Description of Tones
Dial tone: continuous, like the dial tone of a telephone system
Confirmation tone: three beeps
Pre-Announcement tone: 1.5 second duration, 440 Hz
Talk-back Warning tone: 1.5 second duration, 440 Hz
Programming Ready tone: same as dial tone
Programming/Access Confirmation tone: two beeps
Programming/Access Error tone: beep-hoop, beep-hoop, repeating
Override tone: similar to a "busy signal" on a telephone
Night Bell tone: fast ding-a-ling
Chime: constant period with a sweeping duty cycle
Warble Siren: sweep frequencies up and down
Fast Ring: fast electronic ringer
Steady Tone: steady tone
Door Bell: ding-dong
2-32 Programming The Controller