Installation guide

Input Zone / Group Options Overview
These options apply to zones or groups already configured as inputs (see
"Type of Zone," above). These options are summarized in the
Programming Quick Reference Chart, at the end of this section.
Tone Selection
This is called "Activate Tone via an Input Closure," on the Quick
Reference Chart.
If a zone is configured to be an input and is activated, then a tone may be
selected to be directed to whatever zone(s) are selected in "Tone
Routing," below. The tone may be either Night Bell, Chime, Double
Chime, Siren, or Gong.
For example, you wish to have a doorbell pushbutton input cause a chime
to be heard in certain zones. You have already configured the zone of the
doorbell as an input zone (table 2-12). You need to select the tone
(chime) you wish to be heard in the output zones, when the doorbell is
pressed.
The default setting for this option is NONE (not activated).
Programming Steps
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
1.
2.
3.
Dial [ 9 ] [ 2 ] to select this mode option.
Hear a DOUBLE beep.
Enter the number of the input zone (the zone containing the doorbell
pushbutton). Use ALlAS numbers, if optioned. Otherwise, use
Physical zone/group numbers.
Hear a DOUBLE beep.
Enter the tone option, 0 through 7.
[
0 ] None
[
1 ] Chime
[ 2 ] Siren
[ 3 ] Warble Siren
[
4 ] Night Bell
[
5 ] Fast Ring
[
6 ] Steady Tone
[
7 ] Door Bell
Hear TRIPLE beeps.
Programming The Controller
2-31