Installation guide

Pass DTMF to the Output
This zone output option enables the Touchtone telephone keypad tones
(DTMF) to be passed through the PagePac Pius Controller and output to a
second controller or other ancillary device.
NO Option
NOTE: If you leave NO in option
mode, you may page zone to
zone without exiting system.
System is locked up while you
roam zone to zone.
YES Option
NOTE: If you access a zone that
is enabled for passing DTMF,
you will not be able to switch to
another zone (on the same
controller) except by hanging up
and re-initializing access to the
PagePac Plus system.
The choice is YES/NO, with the default being NO. Operating the unit in
the default mode, you may switch from zone to zone (within the same
PagePac Plus Controller) without hanging up, simply by dialing the zone
number of the zone you wish to switch to. The DTMF tones you dial will
be muted (not sent out as audio) as soon as they are detected by the
controller.
Access to the first zone will be disconnected and you will hear a
pre-announcement tone when the zone switch has been accomplished
(if pre-announcement tone has been enabled).
When you have accessed a zone with this parameter set to YES, DTMF
will be sent out as un-muted audio but the PagePac Plus Controller will
not respond to the DTMF tones (and will not switch zones).
This YES option, with DTMF tones enabled to the output, is useful when
you have more than one PagePac Plus Controller daisy-chained in a
system. The un-muted DTMF tone is passed through the first controller
(not triggering a zone change) to the second controller (or other ancillary
device), where it DOES activate a zone.
Programming The Controller
2-29