Installation guide

Music Enable
This is an individual zone output parameter, that enables background
music to be broadcast to a selected output zone (in the absence of a
higher priority paging output). The choice is YES/NO, with the default
being NO.
Programming Steps First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
You will need to repeat this procedure for each output zone that you wish
to have background music.
1.
2.
3.
Dial [ 7 ] [ 4 ] to select this option.
Hear a DOUBLE beep.
Enter the zone number, of the zone you wish to configure. Use
ALlAS numbers, if optioned. Otherwise, use Physical zone/group
numbers.
Hear a DOUBLE beep.
Enter [
0 ] for NO (Music Not Enabled) or enter [ 1 ] for YES (Music
enabled)
Hear TRIPLE beeps.
To verify the status of Music Enable for a given zone, dial [
7 ] [ 5 ] and
repeat steps 2 and 3 above.
These actions are summarized in table 2-18.
Table 2-18. Music Enable
Feature
Mode Option/
Verify
Dial
Listen
For
Zone/Group
Selection
Listen
For
Choose Option
Listen
For
Default
Music
To Select
74
DoubIe (Z) Double
0–No
Triple
No
Enable To Verify
75
Beep
Beep 1 – Yes
Beeps
2-26 ogramming The Controller