Installation guide

Zone Map Option—Assigning ALIAS Numbers
NOTE: Before doing this
option, you MUST do "Define
Length of ALIAS Numbers"
above. (see table 2-2)
NOTE: If ALIAS numbers are
enabled, you MUST use them
for programming from now on.
Programming Steps
Zone Map permits you to assign the dialing code, called the ALIAS zone
code, that you will dial to access a particular zone by telephone. The
factory default is NONE: no ALIAS numbers are pre-programmed. The
zones are identified by their 2-digit Physical Zone Codes – 01 thru 88- as
the default condition.
Digit string length for an ALIAS code can be 2, 3 or 4 digits, but all ALIAS
codes must have the same number of digits (see table 2-2 to set length).
The [
* ] and [ # ] digits are not applicable digits for zone ALIAS numbers.
Refer to your own Zone Map (table 1-2) and the Example Zone Map (table
1-1), in section 1.
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
1.
2.
3.
Dial [ 6 ] [ 0 ] to select this option.
Hear a DOUBLE beep.
Enter the 2-digit physical zone/group code, of the zone to be given an
ALIAS number.
Hear a DOUBLE beep.
Enter the ALIAS zone/group number you have chosen. (Refer to
your filled-in Zone Map, table 1-2.)
Hear TRIPLE beeps.
To verify the assignment of an ALIAS to a selected zone or group, dial
[
6 ] [ 1 ] and repeat steps 2 and 3 above.
These actions are summarized in table 2-12.
Table 2-12. Zone Map Option: ALIAS Number Assignment
Feature
Mode Option/
Verify
Dial
Listen
For
Zone/Group
Selection
Listen
For
Choose Option
Listen
For
Default
Zone Map To Select 60 Double Enter physical
Double
Enter alias
Triple None
To Verify
61
Beep zone/group
Beep
zone/group
Beeps
number.
number.
NOTES:
All zones/zone groups ALlAS codes must have the same number of digits. See table 2-2 to set length of ALIAS
codes.
When an ALlAS number for a zone is changed, all the previous zone options for that zone will be transferred to the
new zone number.
2-18 Programming The Controller