Installation guide

COPY Command
The COPY command can be used to copy the configuration of a zone that
has already been optioned, to one or more additional zones. This saves
recentering the same parameters over again, to duplicate the parameters
of an existing zone. The digits [
1 ] [ 2 ] are used as the COPY command.
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
1.
Dial [ 1 ] [ 2 ] to activate COPY command.
Hear a DOUBLE beep tone.
2.
3.
4.
Enter the zone number that you wish to copy (for example, 01).
Hear DOUBLE beep tone.
Enter the zone number of the beginning of the range of zones you
wish to copy to. To copy the parameters of zone 01 to ALL other
zones, the range zone 02 to 56 would be entered in this step and the
next. To copy to a single zone (for example, 02) enter that zone
number as both the beginning and the end of the range (02 to 02).
in this step, enter only the beginning zone of the zone range.
Hear a DOUBLE beep tone.
Enter the zone number of the END of the zone range to be copied to.
(See explanation in step 3.)
Hear a TRIPLE beep tone.
See table 2-11 for a summary of these actions.
Table 2-11. Copy Command
Copy Dial 12 Double Enter zone
Double
Enter the
Double
Enter end of Triple
Command
Beeps number that is Beeps
beginning of
Beeps the range. Beeps
to be copied.
the range.
NOTES:
Program the PagePac Plus using the physical zone number
Exit the programming mode by dialing #
Programming The Controller 2-17