Installation guide

Input Computer Monitor
Programming Steps
This option turns ON or OFF the inputs of Attendant Access, Telephone
Access, and Night Bell to be recorded and displayed by the Computer
Monitor if you have activated it in the preceding programming option.
The factory default is OFF for all three.
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
You will repeat this procedure 3 times in order to reset all three inputs.
1.
2.
Dial [ 5 ] [ 4 ] to select this option.
Hear a DOUBLE beep.
Dial the code to select an option for one of the three inputs:
[ 0 ] to turn OFF the Attendant Access
[ 1 ] to turn ON the Attendant Access
[ 2 ] to turn OFF the Telephone Access
[
3 ] to turn ON the Telephone Access
[ 4 ] to turn OFF the Night Bell
[ 5 ] to turn ON the Night Bell
Hear TRIPLE beeps.
To verify the status of this option, dial [
5 ] [ 5 ] and repeat step 2 above.
These actions are summarized in table 2-10.
Table 2-10. Inputs to Computer Monitor
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
Input Computer
Monitor
To Select
To Verify
54
55
Double
0 – AA Off
Beep
1 – AA On
2 – T/R Off
3 – T/R On
4 – N.B. Off
5 – N.B. On
Triple
Beeps
AA – Off
T/R – Off
N.B. – Off
General Zone Group Configurations Overview
General Zone and Zone Group Configurations are options that apply to
selected zones or groups, not to the entire system. Refer to the
Programming Quick Reference Chart for a summary of these options. The
paragraphs following "Copy Command," describe each option and give
programming instructions.
2-16 Programming The Controller