Installation guide

VOX Disconnect Timing
This is a loop supervision parameter for the station mode of the Telephone
Interface. The PagePac Plus unit will return to an ON HOOK condition
after no audio is detected in the page mode for the programmed amount of
time. The default time is 30 seconds, but can be varied from 10 seconds
to 60 seconds, in 10 second increments, or can be disabled completely.
Programming Steps
To alter the duration of the VOX Disconnect Timing, first access the
PagePac Plus system and enter the programming mode by pressing [ * ] [ * ]
and entering your Programming password (if optioned). You may exit the
programming mode by dialing [
# ].
1.
2.
Dial [ 5 ] [ 0 ] to select this option.
Hear a DOUBLE beep.
Dial the code to select a duration for the VOX Disconnect Timing:
[ 0 ] to turn OFF
[ 1 ] to select 10 seconds
[
2 ] to select 20 seconds
[
3 ] to select 30 seconds
[
4 ] to select 40 seconds
[
5 ] to select 50 seconds
[
6 ] to select 60 seconds
Hear TRIPLE beeps.
To verify the duration of the VOX Disconnect Timing, dial [
5 ] [ 1 ] and
repeat step 2 above.
These actions are summarized in table 2-8.
Table 2-8. VOX Disconnect Timing
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
VOX Timer
Disconnect
To Select
To Verify
50
51
Double
Beep
Enter Duration
0 – Off
1 – 10 sec.
2 – 20 sec.
3 – 30 sec.
4 – 40 sec.
5 – 50 sec.
6 – 60 sec.
Triple
Beeps
30 Sec.
2-14 Programming The Controller