Installation guide

Talk-Back Warning Tone
This tone is intended to alert a person that their conversation is being
monitored through the paging system loudspeaker. If Talk-back is
optioned for YES, then the choices will be INITIAL, 30 SECOND
REPETITION, or OFF. The default setting for this parameter is INITIAL
and 30 SECOND REPETITION.
Programming Steps
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
1.
2.
Dial [
4 ] [ 4 ] to select this option.
Hear a DOUBLE beep.
Dial [
0 ] to turn OFF. Dial [ 1 ] to select INITIAL tone only. Dial [ 2 ] to
select INITIAL and 30 SECOND repeat.
Hear TRIPLE beeps.
To verify the condition of the Talk-Back Warning tone, dial [
4 ] [ 5 ] and
repeat step 2 above.
These actions are summarized in table 2-7.
Table 2-7. Talk-Back Warning Tone
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
Talk-back Warning
To Select
44
Double 0 – Off
Triple
Initial and
Tones
To Verify
45 Beep 1 – Initial
Beeps
30 sec.
2 – Initial and 30 sec.
Programming The Controller
2-13