Installation guide

Pre-Announcement Tone ON/OFF
The choice for this parameter is ON/OFF, with the default setting ON.
This tone is very similar to the initial talk-back warning tone, in the sense
that it is sent to a zone when the zone is accessed. This tone will be sent
out to both the zone selected and to the telephone interface. After this
tone is sent, you may begin your page message.
Programming Steps First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
1.
2.
Dial [ 4 ] [ 2 ] to select this option.
Hear a DOUBLE beep.
Dial [
0 ] to turn OFF. Dial [ 1 ] to turn ON.
Hear TRIPLE beeps.
To verify the condition (OFF or ON) of the Pre-Announcement tone, dial
[
4 ] [ 3 ] and repeat step 2 above.
These actions are summarized in table 2-6.
Table 2-6. Pre-Announcement Tone ON/OFF
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
Pre-Announcement
To Select
42
Double
0-Off
Triple
On
Tone To Verify 43 Beep 1–On
Beeps
2-12 Programming The Controller