Installation guide
Programming Password
Establishing a Programming password will restrict access to the
programming mode of the PagePac Plus paging system. It is
recommended that access to programming be restricted to the System
Administrator, Telecommunications Manager, or other selected users.
This feature will become active once any programming password has been
entered via the programming mode. You are not required to establish
such a password. The factory-set default programming password is
[
* ] [ * ]. Your Connect and Programming passwords should not be the
same.
If this feature is active and the system has been accessed via the
telephone interface, then after the first digit of your Programming password
is pressed, the dial tone will stop and will not be returned until the correct
password is entered or until the user hangs up and re-enters the system.
Programming Steps
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if previously
optioned). You may exit the programming mode by dialing [
# ].
1.
2.
Dial [
3
] [
2
] to select this option.
Hear a DOUBLE beep.
Enter the Password you wish to use (up to 6 digits). If the password
has fewer than 6 digits, enter the [
# ] to terminate the string.
For example, [
2
] [
3
] [
4
] [
5
] [
6
] [
7
] is a valid password entry. [
2
] [
3
]
[
4
] [
#
] is also a valid password entry, resulting in the password
[
2
] [
3
] [
4
].
If you already have entered a password and now want to remove it
(to have NO password), just enter the [
#
] alone.
Hear TRIPLE beeps.
To verify that the new Programming password has been established, dial
[
3
] [
3
] and repeat step 2 above.
These actions are summarized in table 2-4.
Table 2-4. Selecting a Programming Password
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
Programming To Select
32 Double
Enter Password,
Triple
**
Password
To Verify
33 Beep
enter # to terminate the
Beeps
string
2-10 Programming The Controller