Installation guide

Programming Steps
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
1.
2.
Dial [
3 ] [ 0 ] select this option.
Hear a DOUBLE beep.
Enter the Password you wish to use (up to 6 digits). If the password
has fewer than 6 digits, enter the [
# ] to terminate the string.
For example, [ 1 ] [ 2 ] [ 3 ] [ 4 ] [ 5 ] [ 6 ] is a valid password entry. [ 1 ] [ 2 ]
[ 3 ] [ # ] is also a valid password entry, resulting in the password
[ 1 ] [ 2 ] [ 3 ].
If you already have entered a password and want to remove it (to
have NO password), just enter the [
# ] alone.
Hear TRIPLE beeps.
To verify that the new Connect password has been established, dial
[
3 ] [ 1 ] and repeat step 2 above.
These actions are summarized in table 2-3.
Table 2-3. Selecting a Connect Password
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
Connect
To Select
30 Double Enter Password, enter #
Triple
None
Password To Verify 31 Beep
to terminate the string
Beeps
Programming The Controller 2-9