Installation guide

Connect Password
This feature will not become active until the first time you enter a
password, via the programming mode. The factory default is NO
password.
The Connect password operates as a security block into the paging
system, restricting paging access to authorized users.
You may want to use a short Connect password (2 or 3 digits only) for
ease of use.
When a user accesses the PagePac Plus unit via Telephone Access, a
dial tone will be returned to the user. At this time the user will have
unlimited chances to enter the correct password. If the correct password
is entered, the user will receive the confirmation tone, then a new dial tone
from the PagePac Plus unit, and then can either select a zone, zone
group, or enter the programming mode.
If the wrong password is entered, the user will not receive any confirmation
tone or new dial tone. He can continue to enter digit strings (without
hanging up) until the correct password is entered, or he can hang up and
try again by re-accessing the paging system.
In the event that the user forgets the password, see "Forgot the
Password?"
2-8 Programming The Controller