Installation guide

Define Length of ALIAS Numbers
This system option allows you to set the length (2, 3, or 4 digits) of the
ALlAS number field. The default is 2 digits. If you wish to assign ALlAS
numbers to the paging zones, you must set the length parameter. The
ALIAS number is the dialing extension for the zone. If no ALlAS numbers
are used, the Physical Zone Code is the dialing extension for a zone.
This MUST be done before "Zone Map Option – Assigning ALlAS
Numbers", later in this section. (see table 2-12)
Programming Steps
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and then entering your Programming password (if
optioned). You may exit the programming mode by dialing [
# ].
1.
2.
Dial [ 2 ] [ 0 ] to select this option.
Hear a DOUBLE beep.
Enter [
2 ] [ 3 ] or [ 4 ], to set length of ALlAS number filed (number of
digits).
Hear TRIPLE beeps.
To verify the setting, dial [
2 ] [ 1 ] and repeat step 2 above.
These actions are summarized in table 2-2.
Table 2-2. Defining Length of ALIAS Numbers
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
Number of Zone
Map Digits
To Select
To Verify
20
21
Double
Beep
2 (digits)
3 (digits)
4 (digits)
Triple
Beeps
2
Programming The Controller
2-7