Installation guide

Reset to Factory Defaults
This system option allows you to "undo" all system changes you have
made, in order to "start over." This Reset option takes all programmed
options and restores them to their factory default settings.
First access the PagePac Plus system and enter the programming mode
You may exit the programming mode by dialing [
# ].
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
1.
Dial [ 1 ] [ 0 ] to select this option.
Hear a DOUBLE beep.
2.
Enter [ 2 ] [ 5 ] [ 3 ] [ 2 ] [ 7 ] to reset. (Enter any invalid number string to
escape.)
Hear TRIPLE beeps.
Note that the factory default condition for Connect password is NO
password, and for Programming password the default is [
* ] [ * ].
These actions are summarized in table 2-1.
Table 2-1. Reset to Factory Defaults
Feature
Mode Option/
Verify
Dial
Listen
For
Choose Option
Listen
For
Default
Reset to Factory
Defaults
To Select
10
Double
Beep
Enter 25327 to reset.
Enter any invalid number
string to escape.
Triple
Beeps
25327
(CLEAR)
2-6 Programming The Controller