Installation guide

Zone Map
Description of Zone
Physical Zone Number
Physical Zone Code
NOTE: If an ALIAS number is
assigned to any zone, ALIAS
numbers must be assigned to
ALL zones.
ALIAS Zone Number
Input or Output
NOTE: Attendant Access,
Telephone Access, Night Bell,
and Music input are default
inputs to the PagePac Plus, and
are not to be identified as zones.
Computer Monitor is an optional
output device connected to the
PagePac Plus, and is also not to
be identified as a zone.
The Zone Map is to be filled out by your system administrator or the
person responsible for programming your PagePac Plus system. It assists
in identifying the zones, both inputs and outputs, of your particular system.
Make photocopies of the blank Zone Map to use in laying out your system.
Refer to the example Zone Map for an idea how to proceed.
Write a brief description of each zone in your facility.
Preprinted on the form, this number identifies the zones and groups.
Preprinted on the form, these are the physical addresses (default dial
codes) of the different zones. You would dial this code for a zone if no
ALlAS number has been assigned.
Using ALlAS zone numbers is optional. An ALlAS number for zone is the
extension number you intend to dial to reach this zone. All ALlAS
numbers must have the same number of digits (all 3-digit, or all 4-digit
codes). When assigning ALlAS zone numbers, consider assigning
consecutive numbers to similar zones. Choose numbers that are relatively
easy to remember and easy to enter into the telephone keypad. If you
choose not to use ALlAS numbers, you will use the Physical Zone Codes,
above, to dial the zones.
Write an I-1, I-2, or an O to indicate the type of zone. I-1 means input
priority level 1; I-2 means input priority 2. "Input" and "output" here mean
inputs to or outputs from the controller.
After completing your Zone Map, you are ready to set System Options
(beginning with table 2-1 in section 2) and then do Zone Map programming
(table 2-12).
1-16 Overview