Installation guide

Eight Primary Paging Zones
NOTE: The Zone Option The PagePac Plus Control Unit has eight onboard zones. All eight zones
switches, both on the PagePac
can be optioned via zone option switches (on the rear of the controller) to
Plus Controller and on any
be either 70V audio output zones, input contact-closure zones, or
attached Zone Expansion
Units, MUST be set before the
contact-closure output zones to drive additional remote amplifiers or other
PagePac Plus system is
devices such as security door locks, Each zone may be configured
powered up, and therefore
individually. If a zone is optioned as an input, its priority will be set by
before programming
identifying it as an Input #1 or Input #2 zone.
commences.
48 Expansion Zones
NOTE: Each Zone Expansion
The PagePac Plus Control Unit has the ability via Zone Expansion Units to
Unit has a dip switch that must
access up to 48 external paging zones. it communicates with these
be set (addressed) properly
during installation, and before
expansion zones by using up to three optional Zone Expansion Units (16
power up of the system. See
zones per module).
Installation Guide.
PagePac Plus Amplicenter Interface
The PagePac Plus Controller connects to and controls a PagePac Plus
Amplicenter. The controller draws its internal power from the amplifier and
routes the amplifier’s audio power to the proper zone(s).
Music Input
The background music source is connected to the PagePac Plus
Amplicenter, then its audio signal is passed on to the PagePac Plus
Controller for distribution to zones. The music input will always have the
lowest paging priority. Since the amplifier has a music input volume
adjustment, it can accommodate various input signal levels, such as tape,
CD, or radio.
Overview
1-9