Specifications

Before You Start
Before installing your system, read and understand the safety
instructions. Be sure you have all the necessary parts, tools, and test
equipment, listed below.
Read Important Safety Information on Page 2
1
2
■
■
■
Check Shipping Container Contents
AmpliCenter Unit
Power Cord
This Installation and Use guide
AMPLICENTER D20, D100, D300
INSTALLATION MANUAL
AT&T
PagePac Plus
POWER CORD
AmpliCenter
Installation and Use
Figure 1. AmpliCenter Components
3
Have Required Tools
The following tools are required for the installation of the system
hardware and cabling.
■
■
■
■
■
■
■
■
No. 2 Phillips screwdriver
Standard blade screwdriver (1/4") and small, for terminal block
connections and level adjustments
Wire strippers (24 AWG - 12 AWG)
Telephone test set (optional, for troubleshooting)
Tone out circuit tester (optional, for troubleshooting)
Portable 70V speaker (use cabling pulled for ceiling speakers)
(optional, for troubleshooting)
Volt-Ohm Meter (optional, for troubleshooting)
Four # 8 wood screws, if mounting on wall
3