Specifications
Copyright © 1994 Harris Dracon
All Rights Reserved
Written/Printed in U.S.A.
AT&T 463-248-202
0II722051-300
Issue 3, Sept. 1994
Notice
Every effort was made to ensure that the information in this
guide was complete and accurate at the time of printing.
However, information is subject to change.
FCC Statement (Part 15) - Radio Frequency Interference
The PagePac Plus AmpliCenter generates and uses radio
frequency energy and if not installed and used in strict
accordance with the manufacturer’s instructions, may cause
interference to radio and television reception. Testing is being
conducted for compliance with the limits for a Class B device in
accordance with the specifications in Part 15 of the FCC Rules
and Canadian D.O.C. regulations. This testing is designed to
provide reasonable protection against such interference.
However, there is no guarantee that interference will not occur
in a particular installation If this equipment does cause
interference to radio or television reception, which can be
determined by turning the AmpliCenter unit off and on, the user
is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient the radio or TV receiving antenna.
- Relocate the AmpliCenter unit with respect to the radio or TV
receiver or vice-versa.
- Plug the AmpliCenter unit into a different outlet so that it and
the radio or TV receiver are on different branch circuits.
If necessary, the user should consult the dealer or an
experienced radio/television technician for additional
suggestions. The user may find the following booklet, “How To
Identify and Resolve Radio-TV Interference Problems,” helpful.
This booklet was prepared by the Federal Communications
Commission (FCC) and is available from the U.S. Government
Printing Office, Washington, DC 20402. Stock order
No. 004-000-00345-4.
Trademarks
PAGEPAC, PAGEPAC PLUS and AMPLICENTER are
trademarks of Harris Corporation. Centrex is a registered
trademark of AT&T.
Ordering and Reference Information
The order number for this book is 463-248-202. To order copies
of this book, call:
1-800-432-6600 in the U.S. and
1-800-255-1242 in Canada.
For related product information, refer to the PagePac Plus
System Installation and Configuration and Zone Expansion Unit
Installation and Use Manual for specific information on those
products.
Important Safety Information
Always follow these basic safety precautions when installing and
using the system:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. DO NOT block or cover the ventilation slots and openings.
They prevent the product from overheating. DO NOT place the
product in a separate enclosure or cabinet, unless proper
ventilation is provided.
4. Never spill liquid on the product or drop objects into the
ventilation slots and openings. Doing so may result in serious
damage to the components.
5. Repair or service must be performed by a factory authorized
repair facility or AT&T technician.
6. The product is provided with a UL-CSA approved, 3-wire
ground type plug. This is a safety feature. DO NOT defeat the
safety purpose of the grounding type plug. DO NOT staple or
otherwise attach the AC power supply cord to building surfaces.
7. DO NOT use the product near water or in a wet or damp
place (such as a wet basement).
8. DO NOT use extension cords. The product must be installed
within 6 feet of a grounded outlet receptacle.
9. DO NOT install telephone wiring during a lightning storm.
10. DO NOT install telephone jacks in a wet location unless the
jack is specifally designed for wet locations.
11. Never touch uninsulated wires or terminals, unless the line
has been disconnected at the paging or controller interface.
12. Use caution when installing or modifying paging or control
lines.
Support Telephone Numbers
AT&T provides a toll-free customer Helpline 24 hours a day.
In the U.S., call the AT&T NTSC Group at 1-800-552-3293 or
the AT&T Helpline at 1-800-628-2888 if you need assistance
when installing, programming, or using your system. For service
or technical assistance in Canada, call one of the following
Technical Assistance Centers:
Eastern Canada and Ottawa: 1-800-363-1882
Ontario: 1-800-387-4268
Central and Western Canada:
1-800-663-9817
Domestic and International Approvals
UL813, FCC Part 15, Class A, CSA 950, and D.O.C.
2