Specifications

Connecting Speakers

Locate and mount all speakers in accordance with the

floor plan drawing for this installation

Connect each speaker to the appropriate Home Run or

Speaker-to-speaker wiring scheme as shown on the

wiring plan (See Figure 11, below)

Test speaker wiring for short circuits

Measure the resistance of each home run wire run with an ohmmeter.

Any pair indicating a value of less than 15 ohms must be rechecked for

possible shorted wiring or speakers. Correct and problems and retest.

NOTE: If paging zones use

the talkback feature (available

only when used with PagePac

Plus Controller), cabling must

be shielded and grounded at

the AmpliCenter connector, not

the speaker.

HOME RUN METHOD

SPEAKERS

AMPLICENTER

66-TYPE

CONNECTION

BLOCK

SPEAKER TO SPEAKER METHOD

SPEAKERS

AMPLICENTER

Figure 11. Speaker Run Methods