User guide

DEFINITY Performance Management User Guide, Release 2.0, 585-229-808
7 Administer Reports
Select Managed Nodes
Issue 1
November 1998
Page 141
Result: If the managed node you checked has individual components, a list of
those components displays in the right side of the pane. See the
table following this procedure for a list of report types and
corresponding components.
4 For each system selected, are there any components listed in the right side of
the pane?
• If yes, go to the next step.
• If no, go to step 7.
5 If the managed node has associated individual components for the report type
selected, such as tone receiver types, select which components to report on:
• To select individual components, put a checkmark next to the desired
component in the selection list. The default is all components.
• If you are reporting on a trunk group, go to the next step.
• To select all components, click
Select All.
• To clear all components so that none are selected, click
Clear All.
For additional details about components, see the table
"Report Type and
Component List" on page 142 for a list of report types and corresponding
components.
6 If you are reporting on trunk groups and if there are any trunk group lists
defined for that managed node, you can select an individual, multiple, or any
combination of trunk group lists by clicking on the
Show trunk group lists