User guide

DEFINITY Performance Management User Guide, Release 2.0, 585-229-808
6 Specify Collection Parameters
Specify Default Data Types
Issue 1
November 1998
Page 107
Specify Default Data Types
Introduction This procedure describes how to specify the types of default data to collect for the
entire Performance Management system. Although the data types selected here
will be the default types for the entire DEFINITY system, you can change the data
types for a specific managed node as described in
"Specify Data Types for a
Specific Managed Node" on page 109 . Depending on what is supported by the
managed node you are trying to measure, you can collect data on the following
basis:
•Hourly
• Daily peaks
• Weekly peaks
Retrieve Stored
Data
To retrieve stored data, go to Chapter 7, "Administer Reports" .
Procedure To specify default data types of data to collect, do the following:
1 Click Performance Management > Data Collection Defaults.
Result: Displays the Data Collection Defaults pane.
2 Click the Data Types tab.
Result: Displays the Data Types tab.