User`s manual

5
Getting started
Console installation
Install the telephone lines. Plug one end of telephone line into the
telephone jack at the back of the console. Plug the other end of the
telephone line into the telephone wall jack. If you subscribe to high-speed
Internet service (DSL - digital subscriber line) through your telephone
lines, you must install a DSL filter between the telephone line cord and
telephone wall jack. The filter prevents noise and caller ID problems
caused by DSL interference. Please contact your DSL service provider for
more information about DSL filters.
Make sure your router is connected to the Ethernet network. Plug one
end of the Ethernet cable into the Ethernet jack (
Use only
Supplied
Adapter
L4 L3/4 L2 L1/2
5.1
MS2085 Engraving:
MS2015 Engraving:
Use only
Supplied
Adapter
) at the back of the
console, and plug the other end into the router.
Plug the power adapter into an electrical outlet not controlled by a
wall switch.
4.
5.
6.
Snap the kickstand into the desired grooves until it locks into place. 3.
IMPORTANT INFORMATION
Use only the power adapter supplied with this product. To order a replacement power adapter, visit
our website at www.telephones.att.com, or call 1 [phone].
In Canada, dial 1 [phone].
The power adapter is intended to be correctly oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or
cabinet outlet.
1.
2.