User`s manual

8
Getting started
Console installation (system telephone)
It takes at least one minute for the console to start up
the system and the screen displays Booting... during
startup. The screen displays Is this Console going to
register MS2015 Desksets? ‘SELECT’: Yes ‘CANCEL’:
No. Press SELECT. The screen shows Console is in
system mode.
The console is set to obtain the IP address
automatically by default. The screen displays
Obtaining IP from DHCP server Please wait... when
the console is obtaining the IP from the router. When
an IP is obtained, the screen displays IP obtained:
XXX.XXX.X.XXX Please set an extension number to
this phone.
If the console cannot obtain IP address automatically,
it displays No IP assigned. Check network. and then
the Network setup menu. You need to enter the IP
address manually under the Set static IP menu. See
For installation with use of MS2015 deskset in the
system - set static IP section in the user’s manual
for details.
To set an extension number:
When the console displays IP obtained: XXX.XXX.
X.XXX Please set an extension number to this
phone, press MENU/SELECT.
Press /REPEAT or /SKIP to choose the desired
extension number.
Press MENU/SELECT to save.
The console displays Please wait... and then
Starting... It takes a while for the system to finish
the startup and the console enters idle screen when
the startup is done. The console is named Console by default.
Wait for approximately one minute for console to synchronize, then lift the
handset. If you hear a dial tone, the installation was successful.
NOTE: This telephone provides minimal functionality during a power outage. When AC power
is not available, many telephone features do not function. The telephone uses power from
L1/2 jack to enable you to make and answer calls using only the corded handset on line 1.
1.
2.
3.
4.
5.
Set Ext No.
11
Obtaining IP from
DHCP server
Please wait...
IP obtained:
XXX.XXX.X.XXX
Please set an
extension number
to this phone.
Is this Console
going to register
MS2015 Desksets?
‘SELECT’: Yes
‘CANCEL’: No
If you want to use the console as a stand-alone telephone, skip to
the next page for installation instructions