User`s manual

11
To set static IP when initially setting up the deskset:
Instructions on this page are for users to enter static IP to set up the
deskset, due to a failure in obtaining IP from the router automatically.
If you have successfully obtained the IP from your router, you do not
need to perform the steps below.
If the deskset cannot obtain an IP address from the router after you power
it up, the screen displays No IP assigned. Check network, then displays
the network setup menu.
Press or to scroll to Set static IP, then press MENU/SELECT.
The screen displays Enter IP Use the dialing keys to enter a specific IP.
Press DELETE to delete a character.
Press # to add a dot.to add a dot..
Press /REPEAT or /SKIP to move the cursor to the left or right.
When entering a specific IP, make sure the IP range is not blocked by
the administrator. If you are installing more than one deskset in the
system, keep the first three sets of digits consistent and the last one
different among different desksets. For example, if you enter 192.168.1.1
as the static IP of the first deskset, make sure the first three sets of digits
are also set as 192.168.1 in other system desksets.
Press MENU/SELECT. The screen displays Enter netmask. Use the dialing
keys to enter a specific subnet mask.
Press DELETE to delete a character.
Press # to add a dot..
Press /REPEAT or /SKIP to move the cursor to the left or right.
Press MENU/SELECT. The screen displays Enter gateway. Use the dialing
keys to enter a specific gateway.
Press DELETE to delete a character.
Press # to add a dot.to add a dot..
Press /REPEAT or /SKIP to move the cursor to the left or right.
Press MENU/SELECT to save. The screen displays IP obtained: XXX.XXX.
XXX.X Please set an extension number to this phone.
Press MENU/SELECT. Press /REPEAT or /SKIP to choose the desired
extension number.
Press MENU/SELECT to save. The screen displays Connected to Console
(Console represents the name of the console) and then Starting... It takes
a while for the system to finish the startup. The deskset enters the idle
screen when the startup is done.
Lift the handset. If you hear a dial tone, the installation was successful.
1.
2.
3.
•
•
•
4.
•
•
•
5.
•
•
•
6.
7.
8.
9.
Getting started
Deskset installation (set static IP)