8.
Important Notice Installation Guide An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in “park” or when the vehicle’s parking brake is applied.
Installation Guide MATERIALS INCLUDED IN THIS PACKAGE: 1) 2) 3) 4) MMD85 Video Monitor with DVD player (P/N136D3586) (1 pc) A/V Adapter Cable (112B3227) (1 pc) 2 Pin Power Wire Harness with choke (P/N112B3370) (1 pc) Hardware Package:♦ #8 x 3/4” Self Drilling Screws (4 pcs) ♦ #8 Washers (4 pcs) Dome light Harness (112B3110) (1 pc) Remote Control (136B3591) (1pc) 5) 6) 1. 2. 3. 6. CHOKE 1 2 3 4 5 6 7 8 9 4. 0 3 5 ENTER 5.
VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off). Also find a location that will provide a good grounding point. Generally, this wire can be found at the ignition switch or fuse-box. 2) The mounting method and location will vary from vehicle to vehicle, so this manual will only focus on the installation of the video monitor and related accessories.
Roof Roof support Headliner 5"x9"x3/4" Plywood Block or Optional VOHBKT (4) #8x1" self drilling screws (not supplied) Video unit (4) #8 Flat washers (supplied) (4) #8x3/4" self tapping screws ( supplied) 5 Installation Guide MOUNTING THE VIDEO UNIT
MMD85 Red/Black (Lamp On) Violet/Brown (Lamp Auto) Black/Red (Lamp Common) Dome Light Power Source Line In-V (Yellow) Line In-R (Red) Line In-L (White) Audio Video Input Line Out-V (Yellow) Line Out-R (Red) Audio Video Output Line Out-L (White) Power Harness Item # 3 RCA-Female LINE OUT VIDEO (Yellow) Patch Cord RCA Male to Male INPUT VIDEO 12 VDC Power and Ground Auxillary video display TO OPTIONAL ADDITIONAL MONITOR Line Out Right and Left CHOKE Installation Guide To Secondary AV Monitor
The dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of dome light circuits used, positive or negative switched. Positive systems supply voltage to the interior lights to turn them on, negative switched systems apply ground to illuminate the bulbs. To determine which system you have you must locate the wires at the dome light.
Negative Switched Dome lighting To 3 pin connector Red / black - Lamp on Black / red - Lamp common Violet / brown - Lamp Auto To constant Factory Dome light circuit To constant Factory Door ajar switch or Body Installation Guide Troubleshooting: SYMPTOM: REMEDY: No power at Video Monitor -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor.
Installation Guide © Copyright 2004 AEC 150 Marcus Blvd.
