Specifications

Wall Mounting

If you wall mount a display phone, the display may be

difficult to read, so desk mounting is recommended.

(Wall mounting instructions apply to corded MLS-model

phones only. To wall mount an MLC-6, MDC 9000, or

MDW 9000 phone, follow the instructions in the booklet

provided with the phone.)

Wall Mounting Phones with Separate Stands

Reverse the plastic hook that sits in the earpiece part

of the handset cradle.

To install the telephone stand, gently place the

phone upside down with the low end of the

phone to your right.

Insert the tab on the narrow end of the stand into

the left slot on the base of the phone.

Insert the other tab into the right slot, pushing

the stand down and slightly inward until the

tab locks into place.

Insert the phone cord through the center of the

stand and plug it into the jack on the base of

the phone, then plug the other end into the

modular wall jack.

Mount the phone on the wall plate using the

screw keyholes on the base of the stand. For

proper mounting, the wall plate must be an

AT&T 630B connecting block.

Connect the handset cord as described in “Desk

Mounting,” Step 1A, and label the button

sheet as in Step 3B of that procedure.

Wall Mounting Phones with Fixed Stands

Make sure the telephone cord is unplugged from the

bottom of the phone before proceeding.

Reverse the plastic hook that sits in the earpiece

part of the handset cradle.

Gently place the phone upside down.

C-14

Installation