Specifications

Installing the First System Module (206 only)
IMPORTANT:
If you are adding a Release 4.0 206 module to an
existing system, you must install it as the first module in
order to have access to Release 4.0 system features.
1
2
3
4
Attach the 4 rubber feet to the mounting tracks on the
bottom side of the module.
A)
B)
A)
B)
C)
A)
B)
C-8 Installation
Hold the 206 module in place on the wall with the
line and extension jacks facing left.
Leave at least 1 foot (0.3 meters) clearance at
the top, bottom, and back, and at least 2 feet
(0.6 meters) at the front. This allows you to
access the jacks and slide a second module
onto the first, and ensures adequate
ventilation.
Insert one of the #8 wood screws into the screw
hole at the top of the module.
If you are not installing a second module, insert
the other #8 wood screw into the bottom of the
module. If you are installing a second
module, do not screw in the bottom of the
module at this time.
Tighten the screw(s) until the rubber feet are
snug against the wall. There must be a 3/8" (1
cm.) gap between the wall and the rest of the
module. Do not overtighten—the module will
warp and fail to operate.
Label the line and extension jacks as shown.
If you are installing a 2-module system, go to
Step 1 of the next section, “Installing a
Second Module;” otherwise, go to Step 5 of
“Installing a Second Module” to power up the
system.
Lines
Extensions