Specifications

If There Is No Wiring
If there is no inside wiring, or the existing wiring is not acceptable, you may be
able to install your own wiring. The type of wiring you use depends on how far
the extension is from the system module(s). For extensions that are within:
■
■
■
14 feet (4.3 meters): use the telephone cords included with the system.
100 feet (30.1 meters): use the Extension Wiring Kit (see Table D-1 in
Appendix D).
1,000 feet (304.1 meters): use DIW 4 twisted-pair wire or call AT&T at 1
800 247-7000 (in the continental U.S. only) or your local AT&T Authorized
Dealer.
IMPORTANT:
If you need to run the wire inside walls, through ceilings, or under carpets, call
1 800 247-7000 (in the continental U.S. only) or your local AT&T Authorized
Dealer to arrange for AT&T installation to ensure that the installation meets local
building codes.
Required Parts
You will have up to three types of system component packages; Figure C-3
shows the contents of each package in the area marked by a dashed line.
Check your packages to be sure you have the parts shown here (if not, call the
appropriate support telephone number as instructed on the inside front cover).
First System Module
7-foot
#8
AC
206
Telephone
Rubber
Wood
Power
Quick Reference
Module
Line Cords Feet Screws
Cord
Cards
Second System Module
Module Connector
OR
7-foot
7-foot
Long Wood
Screw
206
Telephone
200
Telephone
Module Self-Tapping
Module
Line Cords
Module
Line Cords
Connector Screws
Figure C-3. Required Parts
C-4 Installation