Instruction manual

Automatic System Answer Button (#111)
This System Programming procedure identifies a button on the system phone at
extension 10 to be used to turn Automatic System Answer on and off.
Related Features
■
■
■
Automatic System Answer affects incoming calls only on lines identified
using
Automatic System Answer Lines (#204).
Calls that ring on lines programmed with Automatic System Answer are
picked up after 2 rings, as a default. To change this number, use
Automatic System Answer Delay (#110).
To record the greeting callers hear when the system answers an incoming
call, use
Automatic System Answer Record/Playback.
Considerations
■
■
An Automatic System Answer button must be programmed on a button with
lights on the MLS-model display phone at extension 10. (This feature will
not work if it is programmed on a button without lights.)
This feature is not available on standard phones.
Valid Entries
1 = Assigned
2 = Not Assigned ✔
3 = Select button (and then press a programmable button to assign Automatic
System Answer to that button)
Programming
To assign or unassign an Automatic System Answer button with lights at
extension 10:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 1 ] [ 1 ] [ 1 ].
2. If you want to assign Automatic System Answer to the first available button on
the system phone, press [ Next Data ] until the display reads:
ASA Button
1 Assigned–Ext10
If you want to unassign Automatic System Answer, press [ Next Data ] until
the display reads:
ASA Button
2 Not Assigned
5-16 Automatic System Answer Button (#111)