Instruction manual

Touch-Tone Enable (F08)
Description
This feature lets a user send touch-tone signals on an outside call over a rotary
line. For example, a user may need to dial touch-tone digits while on a call to a
bank-by-phone service.
Related Procedures
If the system has rotary lines, use Dial Mode (#201) to identify them to the
system.
To activate this feature from within a number stored on an Auto Dial button
or as part of a Speed Dial number, press [
Transfer ] when storing the
number—see
Special Dialing Functions.
Considerations
■
■
■
■
■
This feature is needed only when dialing on a rotary line.
Use Touch-Tone Enable only after a call is connected. For example, use
this feature after dialing a bank-by-phone service that requires you to dial
touch-tone digits.
This feature is available only on system phones.
Programming
You can program the Touch-Tone Enable feature code on an Auto Dial button to
turn on Touch-Tone Enable with one touch. To program the button:
1.
Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ Central Tel Program ].
2. Enter the number of the extension to be programmed with this feature.
3.
Press a programmable button.
4.
Press [
Feature ] [ 0 ] [ 8 ].
5.
Program another button for this extension or exit programming mode.
Using
Press the programmed button or dial [ Feature ] [ 0 ] [ 8 ] when you need to dial
touch-tone digits.
Touch-Tone Enable stays in effect until you hang up.
Touch-Tone Enable (F08)
5-125