Instruction manual

Valid Entries
1 = Assigned ✔
2 = Not Assigned
3 = Select Button (and then press a line button to assign the line to that button)
Programming
To assign lines to a specific extension:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 3 ] [ 0 ] [ 1 ]. The
display reads:
LineAssign
Extension:
2. Enter the extension number to be programmed (10–57). For example, to
program extension 15, press [
1 ] [ 5 ].
A red light appears next to each line button that has a line assigned. To
remove all existing line assignments, press [
Remove ] before selecting a
line. After this point, pressing [ Remove ] removes only the specified line.
3.
Enter the line number (01–24) to be assigned. For example, to select line 01,
press [ 0 ] [ 1 ].
4. At this point:
If you want to assign the line to the first available button with lights on
the system phone, press [
Next Data ] until the display reads:
LineAssign 15 L01
1 Assigned-Ext10
If you want to remove a line assignment, press [ Next Data ] until the
display reads:
LineAssign 15 L01
2 Not Assigned
If you want to assign the line to a specific button, press [ 3 ]. The display
reads:
Line Assign 15 L01
3 Select Button
■
■
■
■
■
Then press a line button to assign the line to that button. If you use
option 3 after a line has been assigned, the line moves from the old
button to the new button you select.
5. At this point:
To program another line for this extension, press [
Next Item ] or [ Prev Item ]
until the correct line number shows on the display. Then repeat Step 4.
To program another extension, press [ Next Procedure ] [ Prev Procedure ] and
begin at Step 2.
6. Select another procedure or exit programming mode.
Line Assignment (#301)
5-85