Instruction manual

Programming
To assign extensions to a Hunt Group:
1.
2.
3.
4.
5.
6.
Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 5 ] [ 0 ] [ 5 ].
At the
Group: prompt, enter a group number (1–7). For example, to select
group 1, press [
1 ]. The display reads:
Hunt Grp 1
Extension:
Enter the number of the extension to be programmed. For example, to select
extension 31, press [ 3 ] [ 1 ].
To assign or unassign the extension, press [ Next Data ] until the appropriate
value displays—see “Valid Entries” on the previous page.
At this point:
To assign or unassign another extension, press [ Next Item ] or [ Prev Item ]
until the extension number shows on the display. Then repeat Step 4.
To program another group, press [
Next Procedure ] [ Prev Procedure ], enter a
new group number, and repeat Steps 3 and 4.
Select another procedure or exit programming mode.
■
■
5-78 Hunt Group Extensions (#505)