Instruction manual

Valid Entries
1 = Assigned (for hunting to groups 1–6, or to group 7 for PARTNER MAIL
Automated Attendant service)
2 = Not Assigned
3 = VMS Line Cover (available only for Hunt Group 7)
Programming
1.
2.
3.
4.
5.
6.
Press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
] [
#
] [
2
] [
0
] [
6
].
At the
Group:
prompt, enter a group number (1–6; 7 for PARTNER MAIL). For
example, to select group 1, press [
1
].
At the
Line:
prompt, enter the line to be programmed. For example, to select
line 1, press [
0
] [
1
].
To assign or remove a line for groups 1–6, or to assign or remove a line or use
VMS Line Cover for group 7, press [
Next Data
] until the appropriate value
displays—see “Valid Entries” above.
At this point:
To program another line, press [
Next Item
] or [
Prev Item
] until the line
number shows on the display. Then repeat Step 4.
To program another group, press [
Next Procedure
] [
Prev Procedure
], enter a
new group number, and repeat Steps 3 and 4.
Select another procedure or exit programming mode.
Group Call Distribution (#206)
5-63